Installation Guide

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Standard Ceiling Mount

Routing the wires

Assembling the fan

Preparing for mounting

□ Loosen, but do not remove, the two setscrews (RR) on the

collar (TT) on top of the motor housing.

□ Align the holes at the bottom of the downrod (B) with the

holes in the collar (TT) on top of the motor housing.

□ Carefully insert the hanger pin (DD) through the holes in

the collar (TT) and downrod (B). Be careful not to jam the

hanger pin (DD) against the wiring inside the downrod (B).

□ Insert the locking pin (EE) through the hole near the end of

the hanger pin (DD) until it snaps into its locked position.

□ Re-tighten the two setscrews (RR) on the collar (TT) on top

of the motor housing.

□ Remove the canopy ring (D) from the canopy (C) by turning

the ring counterclockwise until it unlocks.

□ Remove the mounting bracket (A) from the canopy (C) by

loosening the two canopy screws (FF) located in the “L

shaped” slots.

□ Remove and save the two canopy screws (FF) and lock

washers (GG) in the round holes. This will enable you to

remove the mounting bracket (A).

□ Route the wires exiting the top of the fan motor (F)

through the coupler cover (E), and canopy ring (D).

□ Make sure the slot openings are on top and route the

wires through the canopy (C) and then through the

ball/downrod assembly (B).

WARNING: Failure to properly install the locking pin could

result in the fan becoming loose and possibly falling.