Installation Guide

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Hanging the Fan

Attaching the fan to the electrical

box

□ Loosen the two mounting screws (PP) in the outlet box.

□ Pass the 120-Volt supply wires through the center hole in the

slide-on mounting bracket (A).

□ Install the slide-on mounting bracket (A) on the outlet box by

sliding the slide-on mounting bracket (A) over the two screws (PP)

provided with the outlet box. If necessary, use leveling washers

(not included) between the slide-on mounting bracket (A) and

the outlet box. The at side of the slide-on mounting bracket (A)

should face toward the outlet box, as shown.

□ Securely tighten the two mounting screws (PP).

WARNING: To reduce the risk of re, electric shock

or personal injury, mount to an outlet box marked

“Acceptable for fan support of 35 lbs. (15.9 kg) or less,”

and use the screws provided with the outlet box.

Hanging the fan

□ Carefully lift the fan-motor assembly (E) up to the slide-on

mounting bracket (A).

□ Insert the ball portion of the ball/downrod assembly (B) into

the socket of the slide-on mounting bracket (A).

□ Turn the ball/downrod assembly (B) clockwise until it is

seated with the tab of the slide-on mounting bracket aligned

with the slot in the ball.

□ If using close-to-ceiling mounting, hang the fan on the hook

provided by utilizing one of the holes at the outer rim of the

ceiling canopy (C).

NOTE: The mounting bracket (A) is designed to slide into

place on an outlet box with the outlet box screws (PP).

WARNING: The hook (XX) is only to balance the fan while

making the electrical connections. Failure to hang as

shown may result in the hook (XX) breaking, causing the

fan to fall. The hook must pass from the inside to the

outside of the canopy.

WARNING: When hanging the fan on the hook (XX) it is

critical that you use one of the non-slotted (round) holes

in the canopy (C).