Installation Guide

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Mounting the fan-motor assembly (standard mount)

□ Align the locking slots of the canopy (C) with the two screws

(HH) in the mounting bracket (A). Push up to engage the slots

and turn clockwise to lock in place.

□ Firmly tighten the two mounting screws (HH).

□ Install the two canopy screws (II)(saved from Assembly Step

1 “Prepairing for mounting”) into the holes in the canopy (C)

and tighten rmly.

□ Install the decorative canopy ring (JJ) by aligning the ring’s

slots with the screws in the canopy (C). Rotate the ring

counter-clockwise to lock in place.

WARNING: When using the standard ball/downrod mounting, the

tab in the ring at the bottom of the mounting bracket must rest in

the groove of the hanger ball. Failure to properly seat the tab in

the groove could cause damage to the wiring.

WARNING: The locking slots of ceiling canopy are provided only

as an aid to mounting. Do not leave the fan assembly unattended

until all four canopy screws are engaged and rmly tightened.

Assembly - Hanging the Fan (continued)

Mounting the fan-motor assembly

(close-to-ceiling mount)

□ Carefully unhook the fan from the mounting bracket (A) and

align the locking slots of the ceiling canopy (C) with the two

screws in the mounting bracket (A). Push up to engage the

slots and turn clockwise to lock in place. Immediately tighten

the two mounting screws rmly.

□ Install the two mounting screws (II) (saved from Assembly