Installation Guide

Attaching the blades to the blade

brackets

□ Mount the fan blade (G) to the blade bracket (H) by aligning the

three key-slot holes in the blade (G) with the three posts on the

top of the blade bracket (H).

□ Hold the blade (G) with both hands close to the blade bracket

(H) and press down rmly. Ensure the key-slot holes are

properly seated on the blade bracket (H) posts.

□ While still holding the blade (G) down with both hands, slide

the blade (G) until it engages in the locking mechanism (UU).

Make sure the locking mechanism (UU) at the rear of the blade

bracket (H) springs upward and butts against the edge of the

blade (G), indicating a secure connection.

□ Visually inspect the top of the blade bracket (H) to ensure the

locking mechanism is securely in place.

□ Repeat this procedure for the remaining blades (G).

Assembly - Attaching the Fan Blades

Fastening the blade brackets to

the motor

□ Fasten the blade brackets (H) to the fan-motor assembly (E) by

inserting the alignment post into the slot on the bottom of the

motor and tightening the pre-installed blade bracket screws

by inserting a screwdriver through the access hole (ZZ).

□ Repeat this step for the remaining blade bracket by rotating

the motor until the next blade bracket screw can be accessed

through the access hole (ZZ) in the switch cup cover.

WARNING: Remove the rubber motor stops on the bottom of

the fan before installing the blades or testing the motor.

NOTE: Your fan features revolutionary advancements for quick

and easy blade installation, including an alignment post and

captive blade bracket screws.

IMPORTANT: The switch cup cover has an access hole (ZZ)

to allow the screwdriver to reach the screws in the blade

bracket. Position the blade bracket on the motor and tighten

by inserting the screwdriver through the access hole (ZZ).