Installation Guide

INSTALLATION INSTRUCTIONS
For Model # 25702,25703,25704
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
Fig. 2
MOUNTING THE FIXTURE (Fig. 1)
Note: Illustration (Fig.1) on this manual is for installation
purposes only. It may or may not be identical to the fixture
purchased
1. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
2. Shut off power at the circuit breaker and remove old
fixture from ceiling, including the crossbar.
3. Thread Studs (F) into the pre- drilled holes of the Circula
r
Strap (A) same distance apart as the hole in the back
plate, and lock it in place by hex nut (E).
4. Attach Circular Strap (A) using Junction Box Screws (B)
to the Junction Box (C). The side of the Circular Strap
marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
5. At this point, connect the electrical wires as shown in Fig.
2, making sure that all wire connectors are secured. I
f
your outlet has a ground wire (green or bare copper),
connect the fixture’s Ground Wire to it. Otherwise,
connect the fixture’s Ground Wire directly to the crossba
r
using the Green Screw provided.
FINISHING THE INSTALLATION (Fig. 1)
6. Place the back plate over the junction box and thread
studs through the back plate. Secure assembly with Cap
Nut (N).
7. Slide the glass shade (L) over the socket (M) and secure
it with Socket Ring (K).
8. Install the light bulb in accordance with the fixture’s
specifications. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!) The color correlated Temperature
(CCT) for replacing the enclosed lamp is (2700K).
9. The ballast in each of these models can be replaced by a
qualified electrician without cutting of wires and without
damage to the housing, trim, decorative elements o
r
carpentry to which the fixture is attached. The ballast and
lamp are combined, to replace or install, twist pins into
socket as shown Fig 3.
Your installation is now complete. Return power to the
outlet box and test the fixture.
Caution: CFLs contain Mercury (Hg) Dispose of according
to Local, State and Federal Law.
(www.epa.gov/bulbrecycling).
FIXTURE
WIRES
Black or
Smooth
H
O
USE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
H
O
USE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
H
O
USE
WIRES
Green
(Ground)
In the event that you should have any
installation question or are missing parts, please
contact Customer Service. Customer service
may be reached weekdays a 1-800-527-0998
between the hours of 8:00am and 5:00pm PST
(
Pacific Standard Time
)
.
L
M
K
N
FIG.1
R
LIMITED 2 YEAR WARRANTY
This Fixture is covered by a Limited 2 year Warranty
from the Manufacturer, effective from the date of
purchase. This fixture is warranted against defects in
the quality of the housing, trims, diffuser, shades, and
electrical components. Fixture finishes and/or lamps
(bulbs) are expressly excluded from this warranty; refer
to bulb manufacturer for lamp warranty.
Fig. 3
Warning: When
re-lamping,
please use UL
and CUL Listed
Self-Ballast
Fluorescent
Lamp, certificated
by UL1993