Use and Care Manual

There are 5 brightness levels that can be selected:

Pressing the flame button on the control panel will cycle

through the flame settings.

The “ ” buttons on the remote will increase /

decrease flame output.

The thermostat knob controls the thermostat setting.

Turning the knob clockwise will increase

thermostat setting. Rotating the knob

counterclockwise will decrease the

thermostat setting.

When the heater reaches the thermostat setting it will

turn off until the room cools at which point the heater

will turn back on.

This button on the remote control plays or pauses the

undulating emberbed effect.

Operation

3 4

Turning the heat on and off

The HEAT button will turn ON/ OFF the heater.

Push the Power button to supply power to all

functions of the fireplace and put the unit in a

standby mode.

Push the Power button again to turn off all functions.

1 2

Powering the fireplace

NOTE:

Holding the heater button on the control

panel for 10 seconds will disable the heater

function.

NOTE:

All previous settings are held in memory, so the

next time you power up the fireplace, the unit will turn on

with the same settings.

Adjusting the flame

NOTE:

The control panel can be accessed at the right side of the fireplace.

Adjusting the thermostat

Playing the emberbed undulation effect