Manualshelf

Instructions / Assembly

ManualsBrandsHampton Bay ManualsKitchenOxford Collection Wall-Mount Outdoor Black 6-1/2 in. LED Lantern
12345678910
Page 6
3 ea Wire
Nuts (#10)
2 ea Bracket Mounting
Screws (#5)
INSTALLATION INSTRUCTIONS:
PARTS INCLUDED FOR INSTALLATION (parts are not to
scale):
1. Thread the Fixture Mounting Screws (#3) into the provided holes of the Mounting Bracket (#2) as shown. Thread
the Hex Nuts (#4) onto the Fixture Mounting Screws (#3), as shown. Do not tighten the Hex Nuts (#4) at this time.
2. Pull the power supply wires out from the Outlet Box (#1), and mount the Mounting Bracket (#2) to the Outlet Box
(#1), using the Bracket Mounting Screws (#5).
3. Attach the Black Supply Wire (#6) to the Black Fixture Wire (#7) and the White Supply Wire (#8) to the White
Fixture Wire (#9) using Wire Nuts (#10). Connect the Fixture Ground Wire (#11) and the Supply Ground Wire
(#12) together using a Wire Nut (#10). Wrap all wire connections with electrical tape for a more secure connection.
Note: If you have electrical questions, consult your local electrical code for approved grounding methods.
4. Place the Wall Plate (#13) over the Outlet Box (#1) and onto the Fixture Mounting Screws (#3), and adjust the
Fixture Mounting Screws (#3) until they protrude out from the Wall Plate (#13) 1/4". Remove the Wall Plate (#13)
and secure the position of the Fixture Mounting Screws (#3) by tightening the Hex Nuts (#4) against the Mounting
Bracket (#2). Place the Wall Plate (#13) back onto the Fixture Mounting Screws (#3), and secure it into place using
the Lock Nuts (#14) provided.
5. After installing the fixture, caulk upper 2/3 of the Wall Plate (#3) to mounting surface. Leave bottom 1/3 un-
caulked for drainage of any water that might leak into the enclosure. The manufacturer recommends a non-drying
exterior caulking material. A good example is a clear silicone rubber sealant for exterior use.
6. Installation is complete. Turn on power at the circuit breaker or fuse box. Turn the light switch on to activate the
fixture.
1 ea Main Fixture
Body
1 ea Mounting
Bracket (#2)
2 ea Fixture Mounting
Screws (#3)
2 ea Hex
Nuts (#4)
2 ea Lock
Nuts (#14)