Instructions / Assembly

Item #1001 492 872
Model #HD38606
Use and Care Guide
LOW VOLTAGE LED BOLLARD
PACKAGE CONTENTS
Assembly and Installation
1
Attaching and installing the light
2
Connecting the wires
WARNING: Never push the xture into the ground by the lamp body (A) or use a
hammer to insert the spike (B) into the ground.
WARNING: The wire connector (C) contacts have sharp edges for piercing the
main low voltage cable. To avoid injury, do not touch the metal contacts.
CAUTION: The wire from the low voltage power unit shall be 12-16 AWG type
underground low Energy Circuit Cable or SPT2W.
IMPORTANT:
• Protect the wiring by routing it in close proximity to the light tting, or next to a
building structure such as a house or deck.
• The landscape wire and connector can also be hidden under stone or buried
under grass at a maximum depth of 6” (15.24 cm).
• Do not submerge xture in water.
WARNING: Risk of Electric Shock. Install all luminaires 10 ft. (3.05 m) or more
from a pool, spa or fountain.
C
Only for use with low voltage power units with a maximum output rating of 15V,
300W per secondary.
FOR LANDSCAPE LIGHTING SYSTEMS ONLY. OUTDOOR USE ONLY. THE DEVICE IS
ACCEPTED AS A COMPONENT OF A LANDSCAPE LIGHTING SYSTEM WHERE THE
SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR LOCAL
INSPECTION AUTHORITIES HAVING JURISDICTIO
N.
ETL LISTED UNDER MODEL # U000-1713
Please read and save these instructions
Part Description Quantity
A
Body
1
B
Spike
1
C
Connector
1
qCarefully remove the xture from its protective packaging.
qAttach the spike (B) to the body (A) by turning clockwise.
qPlace the wire connector (C) on opposite sides of the low voltage
cable (not included) where the xture will be located.
qAlign and t the main low voltage cable vertically to the slot of the
wire connector (C) as shown.
qPress the wire connector (C) together until fully seated and locked
around the cable. Pre-set prongs will pierce the cable insulation
and establish contact. Turn on the power unit. If the light xture
does not turn on, repeat the previous steps.
qOnce the clip-on connector (C) is in place, it is recommended to
wrap it with electrical tape for additional protection.
qCAUTION BE CAREFUL! THE WIRE STABS ARE VERY SHARP!
qAfter all xtures are installed, turn on the transformer.
CAUTION: Safe for outdoor operation
WARNING: Install in accordance with all local codes and ordinances.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
A
B
C
A
B