Instructions / Assembly
2
Assembly and Installation (continued)
Installing the fixture on a surface using plastic anchors
2
Connecting the wires
□ If installation requires the plastic anchors (BB), then place the cardboard
template (CC) on the mounting surface and mark where the holes should be
for the self-threading screws (AA).
□ At those marks, drill two 10 mm holes on the mounting surface.
□ Push the plastic anchors (BB) into the two holes until the heads of the plastic
anchors (BB) are flush with the mounting surface.
□ Continue the assembly using either of the applicable Step 1 procedures on
page 1.
WARNING: The wire connector (C) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch the
metal contacts.
CAUTION: The wire from the low voltage power unit should be 12-16
AWG type underground Low Energy Circuit Cable.
IMPORTANT:
□ Protect the wiring by routing it in close proximity to the light fitting,
or next to a building structure such as a house or a deck.
□ The landscape wire and connector can also be hidden under stone
or buried under grass at a maximum depth of 6 in. (15.24 cm).
□ Do not install the fixture within 10 ft. of a pool, spa, or fountain.
□ Do not submerge the fixture in water.
□ Place the wire connector (C) on opposite sides of the low voltage cable
(not included) from the transformer (not included) where the fixture will
be located.
□ Align and fit the main low voltage cable vertically to the slot of the wire
connector (C).
□ Press the wire connector (C) together until it is locked around the main
low voltage cable. The pre-set prongs will pierce the cable insulation
and establish contact with the electrical wire inside.
□ Once the wire connector (C) is in place, it is recommended to wrap it
with electrical tape (not included).
□ After all fixtures are installed, turn on the transformer.