Product Manual

C1000 - User Guide Rev: 9SEP2011 Page: 8
Caution: Always, before using the C1000 lift system, the lift, track and sling (s)
must be visually checked for any unusual wear, or damage. Refer to the user manual
with each piece of supplied equipment to determine what should be checked. Should
anything look unusual contact your local Prism Medical dealer prior to use.
Failure to comply with this caution could result in serious injury to the operator, the
individual being lifted and/or damage to the lift.
Operation
Turning the lift ON and Automatic OFF
Figure 4B - Power traverse hand
control
Press any
button to
turn ON
Refer to figures 4A, 4B and 4C to determine the hand control that is attached to the lift.
To operate the lift it must first be turned ON with the use of the hand control. This can be done by pressing any button
on the hand control. The indicator light located on the underside of the lift will turn GREEN and the display screen will
turn on. Refer to Figure 4D. If the lift fails to turn ON at anytime, ensure that the EMERGENCY STOP/ LOWERING
CORD has not been pulled and that the plastic clip at the end of the red cord has not come out, see page 13 for details.
To conserve battery power the lift will automatically shut off after approximately 2 minutes on non-use.
If the batteries of the lift are low and require charging, the indicator light located on the underside of the lift will turn
ORANGE, and a slow beeping audible alarm will sound. The display will also indicate low battery.
If the batteries of the lift are completely discharged and require charging, the indicator light located on the underside of the
lift will turn RED, and a fast beeping audible alarm will sound. See figure 4E. The lift will not raise or lower and the display
will indicate 0% battery.
Figure 4D - Lift ON indicator
Figure 4A - Manual traverse hand
control
Press any
button to
turn ON
Figure 4C - Motorized traverse “H”
system hand control
Press any
button to
turn ON
Figure 4E - Low battery indicator