3 Post Pressure Fit System Owner’s Manual Use and Care Trouble Shooting Warranty Information
Table of Contents 3 Post Pressure Fit System Introduction........................................................................................... 3 Overview of the 3 Post Pressure Fit System .............................. 3 Placement of the 3 Post Pressure Fit System ........................... 4 Components of 3 Post Pressure Fit System ............................... 5 Component list .....................................................................................
CAUTION: DO NOT ATTEMPT TO USE THIS EQUIPMENT WITHOUT FIRST UNDERSTANDING THE CONTENTS OF THIS MANUAL. Introduction Before using this equipment, and to ensure the safe operation of your Pressure Fit System, carefully read this entire manual, especially the section on “Requirements & Cautions”. The Pressure Fit System is designed to be used in conjunction with Prism Medical Ltd. portable lift units, accessories and slings.
Placement of the 3 Post Pressure Fit System in a Room MIN. 6 FEET MAX. 8 FEET T EE 7 F FEET . N MI X. 10 MA DE WI SWIVEL TROLLEY ADJUSTABLE TRACK LIFT TROLLEY SIDE SUPPORT ASSEMBLY MIN. 7 FEET MAX. 9 FEET HEIGHT Figure 1A– FULLY ASSEMBLED 3 POST PRESSURE FIT SYSTEM Figure 1-A shows 3 post pressure fit system set up in a room. In this drawing arrangement, a general placement of a bed is shown in relationship to the Pressure Fit System.
Components of the 3 Post Pressure Fit System Adjustable Track Swivel Trolley Lift Trolley Supporting Post Sections Bottom Foot Top Foot Figure 1B - DISASSEMBLED 3 POST PRESSURE FIT SYSTEM 3 Post Pressure Fit System - User Guide Rev: 2lst September, 2011 Page: 5
Component List The following components are included with your new Pressure Fit System: Description Quantity Bottom Foot 3 Top Foot 3 Supporting Post 3 Adjustable Track 2 Swivel Trolley 1 Lift Trolley 1 Owners Manual 1 Warranty Card 1 Specifications of the Pressure Fit System High-strength lightweight Aluminum Portable or semi-permanent installation Eliminates the mounting of a connection system in the ceiling Pressure gauge indicator to help ensure proper installation Quick attachment wit
Trouble Shooting Should problems arise with the use of the Pressure Fit System review the following chart. Find the fault and complete the recommended solution. If the fault is not found and/or the solution does not correct the problem contact your local authorized dealer for service immediately. Fault Reason Recommended Solution Visually the system is not aligned straight. 1. 2. 3. 4. Level is not working. Floor is not leveled. Level is damaged. Post was knocked with impact.
Fault Reason Recommended Solution The adjustable track is not locking on the Post Pins. 1. One or more track connector Bracket(s) are damaged or broken. Track lock pin(s) is(are) broken or damaged. Do not use the system. Contact your local authorized dealer immediately. Track connector hooks are not sitting right on the post pins. 1) Check “ Mounting adjustable Track Assembly instructions” in the user’s manual. 2) Check visually to ensure track connector hooks are sitting at the same height. 2.
General Inspection and Maintenance Failure to follow inspection and maintenance instructions below as instructed may result in serious injury or death. Periodic general inspection and maintenance should be performed by a person who is properly qualified and trained with the use and care of The Pressure Fit System. Any defects and damage to the Pressure Fit System that have lead to corrective actions should be noted and dated by the inspector.
General Inspection and Maintenance A) Each Use - To be completed by User Prior to each use, the 3 Post Pressure Fit System and associated lift, accessories and sling (s), must be visually inspected. Refer to the lift, accessory and sling user guides for specific details regarding their inspection. Should any of the these items below fail the inspection do not use the Pressure Fit System Contact your local authorised dealer for service.
Warranty This Warranty does not affect or in any way limit your Statutory Rights 1) Subject to the exclusions set out in Clause 2, the conditions set out in Clause 3 and the limitations set out in Clause 4, Waverley Glen Systems Ltd., as sole licensed representative of Corven Healthcare Inc., guarantees all equipment supplied as new against failure within the period of 1 year from date of purchase by virtue of defects in material or workmanship.
