Use and Care Manual

Stand Cover

ASSEMBLY

INSTRUCTIONS

www.hangoutpod.com

Drape Cover over the Stand enrely.

Aach each strap at the boom of the Cover to the

adjoining foot of the Stand. Posion the straps within the

metal hooks, where the base strap of the Stand also sits.

Pin open by rolling each side of the Cover back and

tying it to the Stand pole.

To easily remove, simply pull the rope at the top of the Cover.

Center the opening of the Cover so it's posioned at

the wide entrance of the Pod, and is sing evenly over

the Stand.

PAGE 1
Stand Cover ASSEMBLY INSTRUCTIONS 1 Drape Cover over the Stand entirely. 2 Center the opening of the Cover so it's positioned at the wide entrance of the Pod, and is sitting evenly over the Stand. 3 Attach each strap at the bottom of the Cover to the adjoining foot of the Stand. Position the straps within the metal hooks, where the base strap of the Stand also sits. 4 Pin open by rolling each side of the Cover back and tying it to the Stand pole.
PAGE 2
Stand Cover CARE, SAFETY & WARRANTY IMPORTANT Please read & retain instructions to ensure safe use & warranty. CARE INSTRUCTIONS Not designed to be set up outside permanently. Store or pack away in between uses. During periods of inclement weather of any kind, dry all elements and pack or stow away to avoid damage, injury, wear and tear and voided warranty Always ensure all elements are packed away COMPLETELY DRY. Clean Cover using a damp cloth only. Line Dry / Hang to dry. Do not bleach.