CARBON INFRARED HEATER Model Numbers: 9711051, 9711052 ASSEMBLY & OPERATING INSTRUCTIONS Please read carefully and save these instructions
Warning THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. The supplier will not be liable for any damages caused by failure to follow these instructions. IMPORTANT SAFETY INSTRUCTIONS PLEASE READ CAREFULLY - The infrared heater is designed for safe operation. Nevertheless, installation, maintenance and operation of the heater can be dangerous.
16. ALWAYS allow heating element to cool at least 10 minutes before touching any part of the heater. 17. Do not use near or in the immediate vicinity of a bath or swimming pool or any source of water. Never immerse unit, cord or plug in water or any other liquid. 18. This heater is not intended for use in bathrooms, laundry rooms and similar indoor locations; never locate the heater where it may fall into a bathtub, sink or other water container. 19. Do not leave the appliance unattended when in use.
INSTALLATION Tools required (not provided): Pencil Hammer Level Screw Driver Power Drill and drill bits A wall/ceiling mounting bracket is provided with the heater which has been specifically designed to allow this product to be fitted to a wall or ceiling. Before drilling the holders, confirm that the wall is solid and that there are no hidden water pipes or electric wires. CAUTION! The appliance must be installed on a solid surface.
Wall Installation: Maximum Angle Minimum Angle Ceiling Installation:
Wall / Ceiling Mounting: To install the plastic anchors into the wall, use a drill to place a hole in the wall. Using the hammer, tap the plastic anchor into the wall until it is flush. Cord Positioning: The cord side of the heater should face downward when installed vertically or on an incline. Correct Installation Incorrect Installation Installation with stand: REMOTE CONTROL INSTRUCTIONS: 1. POWER BUTTON: Turns the heater on/off. 2. UP BUTTON: Increase temperature, timer and level. 3.
4. LEVEL BUTTON: Press the level button to adjust the 3 heat levels (L1, L2, L3) by pressing up and down buttons to increase or decrease the heating level. 5. TIMER BUTTON: To set the timer from T0-T9, which is the number of hours it will run. T0 will display and then adjust to the number of hours you would like to set, using the up and down buttons (2 and 3). To replace the battery, press the battery compartment release button and then slide out the battery tray.
1. Always disconnect the heater from the electrical supply and allow it to cool before attempting to work on it. 2. If the heater has collected dust or dirt inside the unit or around the heating element, have the unit cleaned by a qualified service agent. Do not operate the heater in this condition. 3. The only maintenance required is cleaning of the external surfaces of the heater. 4. Do not touch the heating element with bare fingers, as residue from your hand could affect the life of the lamp.