User Manual

1
GETTING START
①Shortcut keys:
Long press this button to enter the menu, and choose shortcut key function;
After setting, press this button single time to respond to the corresponding function.
②Confirm button:
When setting the source parameter, after entering the character, press the button to
confirm.
③ Automatically setting button:
It automatically adjust the horizontal and vertical scales of the oscilloscope
automatically and set the trigger coupling, type, position, slope, level and mode,
etc., to acquire a stable waveform display.
④ Zoom and move keys:
In the trigger menu, the left and down keys push the trigger level down, and the right
and upper direction keys push the trigger level up;
In the channel menu, the upper and lower direction keys change the zero level
position of the channel, and the left and right direction keys change the volt/div of
the channel;
In the time base menu, the upper and lower direction keys change the time/div, and
the left and right direction keys change the horizontal trigger position;
In DMM, switch measurement function;
In generator, after choosing a parameter, the left and lower direction key will reduce
the parameter value, the right and up direction key will increase the parameter
value; it is also used for the digital selection of the virtual keyboard.
⑤Stop and Run:
In scope, stop or run the waveform acquisition;
In DMM, hold the measuring data or update data;
In generator, turn on or off the waveform output.
GETTING START