Product manual

Page 3For technical questions, please call 1-888-866-5797.Item 62183
Use Precautions
1. Do not exceed 3,000 lb. Working Load
Limit. Be aware of dynamic loading!
Suddenly starting or jerking against
load may briefly create excess
load causing product failure.
2. Inspect before every use; do not use if
damaged, faded, frayed, or partially cut.
3. Lay dampening blanket over rope
before winching to prevent whiplash.
4. Keep away from sharp edges and from
high heat, such as exhaust components.
5. Keep at least 10 full wraps
of rope around the drum
when winching. Synthetic rope
requires more wraps than wire rope.
Rope attachment cannot support load.
6. Do not wrap rope around
anchor point. Use a strap.
7. This product is not a toy. Do not
allow children to play with this
item or nearby during use.
8. Do not allow rope to slip
through your hands.
9. Use as intended only.
Maintenance Precautions
1. Wash used portion of rope
carefully after use.
2. Store out of sunlight. Cover winch
to prevent premature weathering.
Installation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
1. Remove set screw and old rope from
winch, and smooth out any burrs and
sharp edges from winch drum, set screw
end, and fairlead using sandpaper.
2. Insert plain end of rope through winch
drum so that it extends a couple of
inches out the other end of the hole.
3. Insert and tighten the set screw
securely. The top of the set screw must
not extend above the drum surface.
4. Lay the end of the rope across
the winch drum, and wrap the first
layer over it to hold it in place.
5. Turn on vehicle’s engine, and
use winch IN control to carefully
wrap wire rope around drum.
WARNING! Keep fingers clear
to prevent entanglement.