Owner's Manual

ManualsBrandsHarbor Freight Tools ManualsChainsawsHarbor Freight Tools 97360

Page 13SKU 97360 For technical questions, please call 1-800-444-3353.

Breaker by pushing in the button. Then,

turn the Power Switch to its “ON” position

to resume cutting. (See Figure 11.)

Note: If the Pump fails, rst try clearing the Filter

of debris and make sure it is not plugged. If Pump

still does not operate properly, it must be replaced.

To Make A Miter Cut:

FIGURE 13

SCALE

RAIL

(49)

BUTTERFLY KNOB

(47)

ANGLE

CUTTING

GUIDE (46)

45° ANGLE

CUTTING

GUIDE (65)

Loosen the Buttery Knob (47) on the

Angle Cutting Guide (46) and position the

Angle Cutting Guide at the desired angle

to the Scale Rail (49). Then, retighten the

Buttery Knob (47). (See Figure 13.)

2. For a 45 degree cut, use the 45° Angle

Cutting Guide (65) that is included as

an accessory item. Hold the tile against

the Guide and slide the Guide down the

Scale Rail (49). (See Figure 13.)

3. To cut the tile, follow the same

procedure as outlined in the section

“To Make A Straight Cut”.

To Make A Bevel Cut;

FIGURE 14

KNOB

(22)

RIGHT END

LEFT END

KNOB

(22)

Loosen the Knob (22) on each end of the

Tile Saw. Also loosen 2 Bolts, (located

on lower end of each Rail Stand (24 &

41). Tilt the Slide Rail (26) to the desired

angle as indicated on the Angle Scale

(43). Then, retighten the two Knobs,

and two bolts. (See Figure 14.)

2. To cut the tile, follow the same

procedure as outlined in the section

“To Make A Straight Cut”.