Owner's Manual

Page 14SKU 97360 For technical questions, please call 1-800-444-3353.
To Change The Saw Blade:
WARNING! Make sure the Power Switch (37)
of the Tile Saw is in its “OFF” position and
that the unit is unplugged from its electrical
outlet before performing this procedure.
1.
FIGURE 15
BLADE GUARD
(12)
BOLT (91)
SPRING
WASHER
(89)
WASHER
(88)
BOLT (91)
SPRING
WASHER
(89)
WASHER
(88)
Remove the Bolts (91), Spring Washers
(89), and Washers (88) from the Blade
Guard (12). (See Figure 15.)
2. Carefully lift up and move the Blade
Guard (12) away from the catch on
the top end of the motor support to
expose the Saw Blade.
(See Figure 16.)
3. CAUTION! Wear heavy-duty work
gloves to avoid cuts to hands.
4.
FIGURE 16
BLADE GUARD
(12)
OUTSIDE
FLANGE
(5)
NUT (6)
ROTATION
ARROW
SAW
BLADE
(4)
With one Wrench (71), hold the end
of the Motor Spindle rmly and with
the other Wrench (70) provided,
unscrew and remove the Nut (6) by
turning it clockwise. Next, remove
the Outside Flange (5) and remove
told Blade. (See Figures 16 and 17.)
FIGURE 17
INSIDE
FLANGE
(3)
(DO NOT
REMOVE)
WRENCH
(70)
SAW BLADE
(4)
WRENCH
(71)
5. Install a new Saw Blade (not
included). Always use Continuous
Rim Diamond Saw Blades with a
7” diameter, 5/8” round arbor hole,
and rated at 3550 RPM or higher.
(See Figure 16.) CAUTION! Never
ip over a used Saw Blade.