Owner's Manual

Page 4SKU 97360 For technical questions, please call 1-800-444-3353.
equipped with an electric cord having an
equipment-grounding conductor and a
grounding plug. The plug must be plugged
into a matching outlet that is properly
installed and grounded in accordance
with all local codes and ordinances.
2. Do not modify the plug provided – if it will
not t the outlet, have the proper outlet
installed by a qualied electrician.
3. Improper connection of the equipment-
grounding conductor can result in a risk
of electric shock. The conductor with
insulation having an outer surface that is
green with or without yellow stripes is the
equipment-grounding conductor. If repair or
replacement of the electric cord or plug is
necessary, do not connect the equipment-
grounding conductor to a live terminal.
4. Check with a qualied electrician or service
personnel if the grounding instructions are
not completely understood, or if in doubt as
to whether the tool is properly grounded.
5. Use only 3-wire extension cords that
have 3-prong grounding plugs and 3-pole
receptacles that accept the tool’s plug.
6. Repair or replace damaged or
worn cord immediately.
125 V~ 3-Prong Plug and Outlet
(for up to 125 V~ and up to 15 A)
Grounding
Pin
7. This tool is intended for use on a circuit
that has an outlet that looks like the one
illustrated above in 125 V~ 3-Prong Plug
and Outlet. The tool has a grounding plug
that looks like the plug illustrated above
in 125 V~ 3-Prong Plug and Outlet.
8. The outlet must be properly installed
and grounded in accordance with
all codes and ordinances.
9. Do not use an adapter to connect
this tool to a different outlet.
110-120 V~ Double
Insulated Tools: Tools
with Two Prong Plugs
Outlets for 2-Prong Plug
1. To reduce the risk of electric shock, double
insulated equipment has a polarized plug
(one blade is wider than the other). This
plug will t in a polarized outlet only one
way. If the plug does not t fully in the outlet,
reverse the plug. If it still does not t, contact
a qualied electrician to install the proper
outlet. Do not change the plug in any way.
2. Double insulated tools may be used in either
of the 120 volt outlets shown in the preceding
illustration. (See Outlets for 2-Prong Plug.)
Tile Saw Safety Warnings
For Your Own Safety Read Instruction
Manual Before Operating Saw
1. Wear eye protection.
2. Use saw-blade guard and spreader
for every operation for which it can be
used, including all through sawing.
3. Keep hands out of the line of saw blade.
4. Know how to reduce risk of kickback.
5. Do not perform any operation freehand.
6. Never reach around or over saw blade.
7. Make sure the workpiece is supported
at all times while sawing.