Owner's Manual

Page 8SKU 97360 For technical questions, please call 1-800-444-3353.
REV 10d
SPECIFICATIONS
Electrical
Requirements
120 V~ / 60 Hz / 9.2 A
Motor Speed 3550 RPM
Blade Diameter
(Diamond Blade
Sold Separately)
7" Diameter / Continuous
Rim Blade Rated at 3550
RPM or Greater
(SKU 67111 Diamond
Wet Blade available from
Harbor Freight Tools)
Maximum Cutting
Capacity
1” @ 45°
1” @ 90°
Maximum Tile Size
Floor and Wall Tiles:
24” x 24”
Marble and Brick:
25” long
Saw Bevel Capacity
0° to 45° in 2.5° Increments
- Left Tilt Only
Rip Fence Scale
0” to 8-1/4” in 1/8”
Increments
Arbor Size 5/8”
Accessories Two Arbor Nut Wrenches
Switch Waterproof On/Off Switch
E105017
UNPACKING
When unpacking, make sure that the
item is intact and undamaged. If any parts are
missing or broken, please call Harbor Freight
Tools at 1-800-444-3353 as soon as possible.
INSTRUCTIONS FOR
PUTTING INTO USE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including all
text under subheadings therein before
set up or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the tool to
its “OFF” position and unplug the
tool from its electrical outlet before
assembling or making any
adjustments to the tool.
Note: For additional information regarding the
parts listed in the following pages, refer to the
Assembly Diagram near the end of this manual.
Assembly
Note: For additional information regarding the
parts listed in the following pages, refer to the
Assembly Diagram near the end of the manual.
WARNING! Always make sure the Power
Switch of the Tile Saw is in its “OFF” position
and the unit is unplugged from the electrical
outlet prior to assembly, adding accessories,
or making adjustments to the unit. Be sure to
wear heavy-duty work gloves when making
any kind of adjustments to the unit.
1. Unpack the Tile Saw, and with
assistance, carefully lay the tool on its
side on a at, level oor surface.