Product manual

SKU 99823 For technical questions, please call 1-800-444-3353. Page 8
Switch the Motor on.2.
Figure 5
Guide
Slots
3. Hold the knife handle towards you
and insert the heel end of the blade
into the Guide Slot. See Figure 5 for
all directions in this section.
As soon as the blade touches the 4.
Grinding Wheel (6), slide it with light,
even pressure across the Grinding
Wheel (6) surface to the knife tip,
then remove it. Do not use excess
pressure.
Insert the other side of the knife into 5.
the opposite guide slot and repeat
the same procedure as in number 3
above.
Continue this procedure alternating 6.
sides of the knife blade until a sharp
edge is attained.
Turn off the power to the Motor 7.
Housing with Switch (3).
Using Scissors Attachment
Slide the Scissors and Knife-1.
Sharpening attachment into the Motor
Housing (1), making sure that the
latch snaps into the catch at the lower
side of the attachment.
Attach the Scissors and Knife 2.
Sharpening Attachment to the
grinding wheel side of the Motor
Housing (1), making sure that the
latch snaps into the catch at the lower
side of the attachment.
Turn on the Power Switch (3) and 3.
allow the motor speed to stabilize.
Open the scissors fully. Note: This 4.
tool can only sharpen those scissors
which spread fully (past 90°).
Keeping the idle blade to the right 5.
hand side of the Motor Housing (1),
position the underside of the blade
to be sharpened in the slot across
the face of the Attachment. Position
the blade edge parallel to the right
hand side of the grinding wheel and
with very light pressure slide the
entire length of the blade across the
grinding wheel.
Repeat Step 4 above to sharpen 6.
the other blade. Alternate between
blades until a keen edge is formed
across the edges. Remove scissors
from the sharpener
Turn off the Power Switch (3).7.