User Guide

Form No. GRMWM-0505
4
INSTALLATION
UNPACKING
Glo-Ray
®
Multi-Staging Warmers are shipped with
most components pre-assembled. Care should be
taken when unpacking shipping carton to avoid
damage to unit and components enclosed.
1. Remove unit from box.
2. Remove information packet. To prevent delay
in obtaining warranty coverage, fill out and
mail in the warranty card.
3. Remove tape and protective packaging from
all surfaces of unit.
4. The GRMW-3 and GRMW-4 series units are
supplied with pan dividers. To install them, place
the dividers in the channels provided.
(See Figure 4.)
LOCATION
NOTE: Unit must be transported in the upright
position.
For proper operation and maximum performance,
locate the Multi-Staging Warmer in an area where
the ambient air temperature is constant and is
a minimum of 70°F (21°C). Areas which are
susceptible to active air movements or currents
should be avoided, i.e., near exhaust fans, hoods
and air conditioning ducts.
CAUTION
Unit is not weatherproof. For safe and proper
operation the unit must be located indoors
where the ambient air temperature is a minimum
of 70°F (21°C) and a maximum of 85°F (29°C).
Figure 4. Installing Pan Dividers
WARNING
For safe and proper operation, the unit must
be located a reasonable distance from
combustible walls and materials. If safe
distances are not maintained, discoloration or
combustion could occur.
CAUTION
To avoid any injury or damage locate the unit at
the proper counter height, in an area that is
convenient for use. The location should be level
to prevent the unit or its contents from
accidentally falling, and strong enough to
support the weight of the unit and food.