User Guide

Form No. GRMWM-0505
6
MAINTENANCE
GENERAL
Glo-Ray
®
Multi-Staging Warmers are designed for
maximum durability and performance, with minimum
maintenance.
WARNING
To avoid any injury, turn the power switch OFF,
unplug the unit from the power source and allow
to cool completely before performing any
maintenance or cleaning.
WARNING
To avoid electrical shock or personal injury, do
not steam clean or use excessive water on the
unit.
WARNING
Unit is not waterproof. DO NOT submerge in
water. Do not operate if it has been submerged
in water.
CLEANING
CAUTION
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your unit
marring its appearance and making it
susceptible to soil accumulation.
To preserve the bright finish of the Glo-Ray Multi-
Staging Warmer, it is recommended that the exterior
and interior surfaces be wiped daily with a damp
cloth. Stubborn stains may be removed with a good
non-abrasive cleaner. Hard to reach areas should
be cleaned with a soft brush and mild soap.
Wipe off the polycarbonate front door using a soft,
clean, damp cloth. Do not use glass cleaner.
Glass cleaner may scratch or crack the
polycarbonate surface.
DRAWER REMOVAL PROCEDURE
To remove the drawer for cleaning, follow these
steps.
1. Pull drawer all the way out until access door
stays open.
2. While supporting door, disconnect door linkages
from drawer by lifting up outer sleeve of linkage
and gently pulling away from connection.
(See Figure 6.)
3. Lift drawer up and out of slides to remove.
Figure 6. Disconnecting Drawer from Door
Door Linkage
Door Linkage
DRAWER SLIDE REMOVAL
PROCEDURE
To remove drawer slides for cleaning, follow these
steps.
1. Support access door.
2. Push slides all the way into the warmer cavity.
3. Gently twist slide outward from the bottom and
lift off.
WARNING
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax [phone] or International
fax [phone].
WARNING
This product has no “user” serviceable parts. To
avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Parts when service is required.
WARNING
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts do not have the
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn.