Use and Care Manual

Maintaining the Baffle Filter
Clean the grease filters frequently—we suggest cleaning every
2 months, or more frequently for heavy use.
DO DONT
Your range hood requires some easy routine maintenance to
keep it running efficiently.
Basic Maintenance Instructions
1.
2.
3.
4.
To remove the baffle filters, push down on the latch, tilt the
filter, and lift out.
Replacing the Non-Ducted Recirculation Charcoal Filter
The charcoal filter is not included. It is not washable and
should be replaced approximately every 3 months, or more
frequently for heavy use.
1.
2.
Install the charcoal filter (not included) by removing the
baffle filter and placing the charcoal filter on the side of the
motor and turn to lock its position.
After placing the charcoal filter, re-install the grease filter.
Wash the baffle filters, taking care not to bend them.
Alternatively, place them in dishwater.
Let the baffle filters dry completely.
Reinstall the baffle filters.
1.
2.
3.
Switch off power and remove the baffle filters.
Remove the baffle filters.
Disconnect the light from the range hood.
Push out the light bulb from inside. Install new lights by
connecting the wire and pushing up the light. Reinstall
baffle filters to complete the process.
Cleaning Your Range Hood
This range hood will look great and function correctly for a long time with proper care. Here are a few do's and dont's when
caring for your range hood.
WARNING: Failure to maintain basic standards of care and cleaning will increase the risk of fire.
Clean the range hood with warm, soapy cloth or a
stainless-steel polish.
Clean the hood in line with the grain of the stainless steel.
Don’t use cleaners or cloths that are corrosive or abrasive.
Don’t use detergents with ingredients like chloride, iodide,
or fluoride.
Don’t leave dirt or soap residue on the hood. This can
damage the surface. Wash the hood’s surface and rinse
immediately with clean water.
After cleaning with soap, rinse with clean water and wipe with
a clean, dry cloth.
Don’t let particles, especially construction particles (from
sanding, etc.) enter the hood. Cover the hood during room
renovations.
Check the ducts and vents regularly to make sure they are not
clogged.
Don’t use flammable agents near the stove, as these can
cause explosions.
WM-639 USER MANUAL 11
1.
2.
3.
Remove the oil cup by sliding it out carefully.
To clean, simply use a warm detergent.
Allow the oil cup to dry before reinstalling.sin.
Cleaning the Oil Cup
The oil cup is located in the motor blower and must be
cleaned frequently. Do not let the oil cup get more than
half full.
This range hood requires two LED lamps (120V, 2W)
Replacing the LED Lamps
CAUTION: Always switch off the electrical supply
before replacing LED lamps.
Connection point