Use and Care Manual

WM-639 USER MANUAL 9
6. Assemble the Chimney Top
Raise the top chimney (D) up inside the bottom chimney (C).
Secure the top chimney (D) to the chimney mounting bracket
(B) that is securely attached on the wall with the two chimney
bracket screws (CC) supplied from two sides.
For 10-foot ceiling or higher, we recommend using a chimney
extension. They can be purchased separately on our website
at www.chefrangehoods.com.
7. Install Charcoal Filter (for non-ducted mode)
If you want to use your range hood in non-ducted mode, you
will need charcoal filters. Charcoal filters are not included and
can be purchased separately on our website:
www.chefrangehoods.com
To install the charcoal filter, you’ll first need to remove the
grease filter. Then, install the charcoal filter by placing the
charcoal filter to the side of the blower, turn to lock the filter in
place. The air will flow out from the two grids on the two sides
of the chimney top.
After placing the charcoal filter, re-install the grease filter.
The charcoal filter is not washable and should be replaced
approximately every 3 months, or more frequently for heavy
use.
5. Assemble the Chimney Bottom
Carefully slide the bottom chimney (C) down outside the top
chimney (D), and then carefully place the bottom chimney (C)
into the recessed area of the hood body top.
If you feel that extra security is needed, fix the bottom
chimney (C) with two previously removed chimney bottom
screws (DD) supplied from side of hood body.
Be Careful with Electrical Connections.
WARNING: Electrical wiring must be done by a
qualified person(s) in accordance with all applicable
codes and standards. Turn off electrical power at service
entrance before wiring.
WARNING: Do not use the plug and an extension cord
other than the ones initially supplied with the hood.
WARNING:The ground connection of this hood is
compulsory. Do not remove ground prong of the plug.
C
D