User's Manual

79
following setup menu will be shown on your web browser:
Key Length (2): There are two types of WEP key length: 64-bit and 128-bit.
Using ‘128-bit’ is safer than ’64-bit’, but will reduce some data
transfer performance.
Key Format (3): There are two types of key format: ASCII and Hex. When you
select a key format, the number of characters of key will be
displayed. For example, if you select ’64-bit’ as key length, and
‘Hex’ as key format, you’ll see the message at the right of ‘Key
Format’ is ‘Hex (10 characters), which means the length of WEP key is 10
characters.
Default Tx Key (4): You can set up to four sets of WEP key, and you can decide
which key is being used by default here. If you don’t know
which one you should use, select ‘Key 1’.
Encryption Key Input WEP key characters here, the number of
1 to 4 (5-8): characters must be the same as the number displayed at ‘Key
Format’ field. You can use any alphanumerical characters (0-9,
a-z, and A-Z) if you select ‘ASCII’ key format, and if you select
2
3
5
7
6
4
8
10
11
12
9
13