Manual

04/14 Model 7361-7461 Page 2 of 4

LOCATION OF UNIT: The Model 7361/7461 Eyewash should be installed in close

proximity to potential accident areas. It should be clearly identified free from

obstruction and easy to access.

SUPPLY LINE: The minimum recommended line size is 1/2” IPS with 30-90 PSI

(2-6 ATM) pressure. Where sediment or mineral content is a problem, an inlet filter

is recommended.

PLUMBING CONNECTIONS: Inlet supply is female 1/2” IPS. Waste outlet is 1-1/4”

IPS.

TROUBLESHOOTING

PROBLEM

REPAIR CHECKLIST

1. No flow. 1. Check the main shut-off valve.

2. Insufficient water flow. 2. a. Verify minimum 30 psi (2ATM)

flowing supply line pressure.

b. Probable clogging of flow control

due to inadequate line flushing.

Unscrew eye/face wash head and

remove the four screws to

disassemble the head. Clean flow

control and reassemble head. See

SP65 Installation Drawing for

details.

c. Remove cap located on L-Strainer

using a 3/8” allen wrench to access

and clean filter screen.

3. Eyewash or face wash streams

do not meet desired eye level or

are not balanced.

3. Possible blocked flow control or

internal screens, see above

solution. Possible non-leveled

eyewash assembly.

4. Water does not drain properly. 4. Check the main waste line of your

building to see if it does handle the

capacity required for the entire

drainage system.

For more information about Haws products, see our website: www.hawsco.com

HAWS

and other trademarks used

in these materials are the exclusive property of Haws Corporation.