Instructions / Assembly

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 4
General Information
Introduction
This manual contains information for the proper installation and operation of the Hayward Super Pump
®
Series. The
instructions in this manual MUST be followed precisely. Failure to install according to defined instructions will
void warranty.
Product Benefits
 Super-sized 110 cubic-inch basket has extra leaf-holding capacity and extends time between cleanings. Rigid
construction with load extender ribbing assures free flowing operation even with heavy debris loads.
 Exclusive swing-aside hand knobs make strainer cover removal simple and easy.
 See-thru strainer cover lets you see when the basket needs cleaning.
 All components molded of corrosion-proof reinforced thermoplastic for extra durability and long life.
 Uni-bracket mounting base provides stable, stress-free support, plus versatility for any installation requirement.
Adapts to 48 and 56 frame motors.
 Heat resistant, industrial size ceramic seal.
 Rugged, one-piece housing, with full-flow ports, assures rapid priming and continuous operation.
 Service-ease design gives simple access to all internal parts. By disengaging just four (4) bolts, motor and
entire drive group assembly can be removed, without disturbing pipe or mounting connections.
Product Specifications
Installation Instructions
NOTICE
– This product should be installed and serviced only by a qualified professional.
Pump Location
Locate pump as close to pool as practical and run suction lines as direct as possible to reduce
friction loss. Suction lines should have continuous slope upward from lowest point in line.
Joints must be tight (but not over-tightened). Suction line diameter must equal or be larger than
the discharge line diameter.
Though the pump is designed for outdoor use, it is strongly advised to protect the electrical components from the
weather. Select a well-drained area, one that will not flood when it rains. Do NOT install pump in a damp or non-
ventilated location. Keep motor clean. Pump motors require free circulation of air for cooling.
PUMP PART
NUMBER
LENGTH
“A”
SP2600X5 13 3/8"
SP2605X7 14"
SP2607X10 14 3/8"
SP2610X15 15 1/2"
SP2615X20 16 1/2"
SP2621X25 16 1/2"
SP2607X102S 17"
SP2610X152S 17 1/2"
SP2615X202S 18 1/2"