READ THE INSTRUCTIONS CAREFULLY, familiarize yourself with all the parts as shown in the exploded view. The exploded view will also provide a helpful reference when relating to the location of the various parts and how they are mounted.
PARTS LIST.
STEP 1 Measure opening on bottom and cut threshold (4) than opening. STEP 2 Run a bead of silicone caulk along the bottom lip of the threshold and set it in place with the caulk bead to the outside of the shower opening. Press threshold down firmly along the entire length of the piece. STEP 3 Determine if door will swing from STEPS (D right or left wall. Attach pivot bracket arm bottom of pivot jamb (@ . Using 1 3/8" pivot & | support screws @® . rT STEP 4 Use a level to ensure wall are 2 bs plumb.
Follow the appropriate diagram below. Left Pivot Assembly Right Pivot Assembly STEP 7 _STEP 8 STEP 7 ry STEP 8 | TTT STEP STEP 7 Attach pivot bracket arm to top of pivot jamb @® with 1 1/2" screws (© but only drive screws in about 1/3 of the way. STEP 8 Slide top pivot bracket arm Place pivot bushings over both pivot pins. Set door panel 2 down over top pivot pin and tighten in place by placing bottom pivot pin into the open hole in the screws down to secure door in pivot bracket arm (® . position.
For the opposite side of the Unit! STEP © VTA 13) SCREW 11/2" STEP 9 Line up Wall jamb (6) and mark STEP & 5 Drill holes and Insert the wall plugs.) STEP 10 Silicone holes. Set Wall jamb 5) in place and attach into the walls by 1 43. STEP 10 STEP 11 Slide magnetic jamb ® over wall jamb® and position so that door closes against entire jamb from top to bottom. Line up drill with 1/8" bit through adjustment slots along inside edge of magnetic jamb ® and drill a hole into inside leg of wall jamb).
Close door and check to make sure the magnetic strips line up from top to bottom. If it is necessary to adjust the door panel, insert a Phillips head screw driver into the holes at the top and bottom of the door panel on the pivot side (see drawings). By turning the screw clockwise, you will move the panel closer to the magnetic strike and turning the screw counter-clockwise will move the panel away from the strike. CAULK ALL SIDES FINAL STEP: Caulk the inside sides of the shower door frame to seal.