Performance Data Sheet

FML-1-S, FML-3-S, FML-4-S, FML-5-S,
FMM-2-S, FMS-1-S, FMS-2-S, FMW-2-S
Performance Data Sheet
This system has been tested according to NSF/ANSI Standard 42 for reduction of the substance(s) listed below. The concentration of
the indicated substance(s) in water entering the system was reduced to a concentration less than or equal to the permissible limit for
water leaving the system, as specified in NSF/ANSI Standard 42.
HDX • 2455 Paces Ferry Rd. N.W. • Atlanta, GA 30339 • 1-855-849-3589
Flow Rate: 0.5 gpm / 1.89 lpm
Operating Temperature: 33 - 100°F (0.6°C - 38°C)
Operating Pressure: 30 psi (207 kPa) - 100 psi (689 kPa)
Capacity: 300 gallons (1,136 L) or six months
FILTER SPECIFICATIONS
The system conforms to NSF/ANSI 42 for the reduction of chlorine taste and odor. See above for
individual contaminant(s) and reduction performance. Note: Testing was performed under standard
laboratory conditions, actual performance may vary.
System to be used with municipal or well water sources treated and tested on a regular basis to
ensure bacteriological safe quality. Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the system.
It is essential that the manufacturer’s recommended installation, maintenance and filter replacement
requirements be carried out for the product to perform as advertised. Manufactured by Aquamor, LLC,
Temecula, CA.
Limited Warranty: This filter hereunder shall be free from material
defects in material and workmanship for a period of one (1) year from the
date of purchase. To reduce the risk of property damage due to water
leakage, this filter MUST be installed in accordance with the
manufacturer’s specifications and installations. This filter unit must be
replaced every 6 months, at the rated capacity, or sooner if reduced
water flow occurs. Protect form freezing. Failure to follow instructions
and operating specifications will void your warranty. Further,
manufacturer assumes no responsibility or liability for damages arising
out of misuse of the product.
Tested and Certified by NSF International
against NSF/ANSI 42 for the reduction of
chlorine taste and odor.
CHLORINE >97% 2.0 mg/L 1.0 mg/L
% of Influent Max
Contaminant reduction Concentration Allowable