User's Manual

20
Applying the Cuff
 Press your brachial artery approximately 1 inch (2 ~ 3 cm) above
the elbow on the inside of your left arm to determine where your
strongest pulse is.
 Slide the end of arm cuff furthest from the tube through the metal
ring to a loop. The smooth cloth should be on the inside of the cuff.
 If the cuff is located correctly, the velcro will be on the outside of
the cuff and metal ring will not touch your skin.
 Put left arm through the cuff loop.
The bottom of the cuff should be approximately1 inch (2 ~ 3 cm)
above the inner elbow. The tube should lie over the brachial artery
on the inner part of the arm.
 Pull the cuff so that the top and
bottom edges aretightened
around your arm.
 When the cuff is positioned
properly, press the velcro firmly
against the pile side of the cuff.
 Sit on a chair and lay your forearm
on the table sothat the cuff is at
the same level as your heart.
 Relax your arm and turn your arm upward.
 Make sure there are no kinks in the air tube.
*Note ！
y Fit the cuff snugly, leaving enough space for 1 inch (2 ~ 3 cm) between the inner
elbow and the lower edge of the cuff, or the measurement may not be accurate.
y This monitor comes with one size of arm cuff: 9” ~ 17” (23 ~ 43 cm).
y In case the cuff kept pumping up non-stop, open the cuff at once.
y Do not wrap the cuff around any body part other than your arm.
y The device is not supposed to be used when your arm is wounded or injured.