User's Manual

Note

*Note

！

This equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to Part 15

of the FCC Rules. These limits are designed toprovide reasonable protection against harmful interference in a

residential installation.

This equipment generates uses and can radiate radio frequency energy and, if notinstalled and usedin accordance

with the instructions, may cause harmful interferenceto radio communications. However, there is no guarantee

thatinterference will not occur in a particular installation. If this equipment does causeharmful interference to radio

or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try

to correct theinterference by one or more of the following measures:

The user is encouraged to try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

CAUTION:

To assure continued FCC compliance:

1. Any changes or modifications not expressly approved by the grantee of this devicecould void the user's

authority to operate the equipment.

2. This equipment complies with FCC radiation exposure limits set forth for anuncontrolled environment. This

equipment should be installed and operated withminimum distance 20cm between the radiator & your body.

FCC Label Compliance Statement:

This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions:

(1) this device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

*Note

！

“Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate

the equipment”.

Essential Performance compliance criteria:

HL858CB essential performance compliance criteria of IEC 60601-1-2

forimmunity testing:

The following degradations that associated with basic safety and

essentialperformance should not be allowed.

- Component failure;

-Change in programmable parameters;

-Reset to factory default and the unintended default would interfere

withdiagnosis, treatment, or monitoring;

False alarm;

-Initiation of any unintended operation, including unintended

oruncontrolled motion, even if accompanied by an alarm;

-Error of a display numerical value sufficiently large to affect diagnosisor

treatment or monitoring.

-Noise on a waveform in which the noise would interfere with diagnosis

ortreatment or monitoring.