User's Manual

This monitor is designed for operation with batteries or an AC adapter.
Please use only a compatible AC adapter with required voltage and
current as indicated in this manual.
 Press your brachial artery approximately 1 inch (2 ~ 3 cm) above
the elbow on the inside of your left arm to determine where your
strongest pulse is.
 Slide the end of arm cuff furthest from the tube through the metal
ring to a loop. The smooth cloth should be on the inside of the cuff.
 If the cuff is located correctly, the velcro will be on the outside of
the cuff and metal ring will not touch your skin.
 Put left arm through the cuff loop.
The bottom of the cuff should be approximately 1 inch (2 ~ 3 cm)
above the inner elbow. The tube should lie over the brachial artery
on the inner part of the arm.
 Pull the cuff so that the top and bottom edges are tightened
around your arm.
 When the cuff is positioned properly, press the velcro firmly
against the pile side of the cuff.
 Sit on a chair and lay your forearm on the table so that the cuff is
at the same level as your heart.
 Relax your arm and turn your arm
upward.
 Make sure there are no kinks in the air
tube.
*Note
！
 Fit the cuff snugly, leaving enough space for 1 inch (2 ~ 3 cm) between the inner
elbow and the lower edge of the cuff, or the measurement may not be accurate.
 This monitor comes with one size of arm cuff: 9” ~ 13” (23 ~ 33 cm).
 In case the cuff kept pumping up non-stop, open the cuff at once.
 Do not wrap the cuff around any body part other than your arm.

The device is not supposed to be used when your arm is wounded or injured.
Applying the Cuff
Using the AC Adapter
*Note ！
• No batteries are needed when operating with an AC adapter.
• Please unload the batteries when operating with an AC adapter for
an extended period of time.
• Leaving the batteries in the compartment for a long time may
cause leakage, which may lead to damage of the unit.
• Recommend Adapter specification, do not use otherwise:
Input: 100 ~ 240V, AC, 50 ~ 60 Hz
Output: 6V, DC, 1A,
*Note
！
When you use the blood pressure monitor with AC adapter, do not
position the device to make it difficult to disconnect the adapter plug.
17 18