Operation Manual

1
2
3
8
ENGLISH
Power Nozzle
Attaching Power Nozzle:
1. Assemble for suction cleaning.
WARNING – PERSONAL INJURY PRODUCT DAMAGE: Always turn off and
unplug the Majestic
®
before connecting or disconnecting either the hose or motorized
nozzle.
2. Connect wand to nozzle by pushing the female end of the wand over the male end of the
swivel neck of the nozzle until the locking button of the wand snaps into place. The wand
swivels more than 90 degrees allowing it to lie flat on the floor.
3. Plug cord extending from other end of hose into the outlet on the power unit.
CAUTION: The “ON/OFF” markings on the hose feature the international symbols
of “I” for ON and “O” for OFF. This switch only controls turning the Power Nozzle
on or off. To turn the Power Nozzle ON (for carpets) slide the switch to the most
forward position. To turn the Power Nozzle OFF(for wood, tile, and linoleum
floors) slide the switch to the rear position.
NOTICE: This hose contains electrical wires.
Cleaning With The Power Nozzle:
WARNING – PERSONAL INJURY PRODUCT DAMAGE: Do not leave the
Majestic
®
unattended while motor is running. If you are interrupted while cleaning
with the Majestic
®
Power Nozzle (phone calls, unexpected visitors, etc.), be sure to
turn off the power on the Majestic
®
. This automatically turns off the Power Nozzle.
Failure to do so may result in overheating the motors and subsequent damage to the
Majestic
®
and/or floor coverings.
The Majestic
®
Power Nozzle requires no rug surface height adjustment. The shape of the Power
Nozzle body has been specially designed to allow it to be effective on any rug or bare floor surface.
Use long, slow strokes when cleaning. For thicker rugs, use a criss-cross pattern to raise nap and
give them a fluffier appearance.
To clean stairs:
Remove caster set from power unit.
Set Majestic
®
on landing.
Remove wand and connect hose handle directly to Power Nozzle.
STORAGE: Avoid sharp bends in hose by removing hose from the unit before storing.
CAUTION: Do not use on carpets or rugs with fringe or loose fibers.
WARNING: PERSONAL INJURY – KEEP AWAY FROM CHILDREN. Do not
turn Power Nozzle upside down while power brush is energized. Prior to turning
Power Nozzle upside down, always turn off power nozzle and main unit power switch
and disconnect hose assembly from the unit.