- Hearth & Home Technologies Castile Insert Pellet Owner's Manual Installation and Operation

R
September 1, 2008
250-7251F
Page 21
Castile Pellet Insert
1. A 12 volt AC thermostat is required to operate this
pellet appliance. You may use the included wall mount
thermostat or purchase an optional programmable
thermostat or remote control. The included thermostat
is equipped with an adjustable heat anticipator. The
current rating is .05 amps. The anticipator needs to
be adjusted to the lowest setting available.
2. When mounting a thermostat on a wall, be sure to follow
your thermostat installation instructions carefully.
NOTE: Thermostat must be mounted level for accu-
rate readings. The thermostat should be mounted
on an inside wall and not in direct line with the
appliance convection air. Remove any packaging
from inside the thermostat before using.
NOTE: If the thermostat is located too close to
the appliance, you may need to set the tempera-
ture setting slightly higher to maintain the desired
temperature in your home.
3. There is a 4 screw terminal block located on the junc-
tion box to the left of the power cord inlet. The center
2 screws are for the thermostat wires. The outer 2 are
the mounting screws for the terminal block. Figure
21.1.
H. Thermostat Installation
Figure 21.1
Shock hazard.
Do NOT remove grounding prong from plug.
Plug directly into properly grounded 3 prong
receptacle.
Route cord away from appliance.
Do NOT route cord under or in front of appliance.
CAUTION
o trol o
tio o
Reset tto
eat tp t
Sit
o er ord
tlet
T ermostat
lo
se
Red all
Lig t
Red ree mber Lig t
l e Lig t