Owner's Manual

5. Ducts must be of adequate size and duct runs should be as short as possible. Where turns are necessary,

keep turning radius as large and as smooth as possible.

6. The ducting must be air tight. Use a minimum of 2 sheet metal screws at every duct joint. Then, seal the duct

joints with high quality duct tape.

7. Only use ductwork constructed of materials deemed acceptable by state, municipal and local codes.

8. Plan the installation so that all minimum clearances are met or exceeded. Dimensions shown provide minimum

clearances, unless otherwise specified.

IMPORTANT: All dimensions are nominal +/- 1/8”.

FRONT VIEW

*The AL-T7200 Heat Versa Hood is extremely versatile. You can easily convert the Versa Hood

to be rear discharge by attaching a 10” round elbow to the Versa Hood start collar (see Fig. 2).

DO NOT USE flex duct as it can create turbulence and diminish the hood’s performance. Use a

high quality foil duct tape to seal the connection and avoid vibration. Be sure to mount the Versa

Hood with adequate clearance from ceiling to allow for height of elbow used for rear discharge.

These 10” elbows can be purchased at many Home and Hardware stores for a nominal cost.

Model #

(No Blower)

(1250 CFM)

T7236

T7236-12

T7242

T7242-12

T7248

T7248-12

Fig. 4

Fig. 2

Fig. 1

Fig. 3