Full Product Manual

This chime requires 3 “C” alkaline batteries (not included). In typical use,
alkaline batteries will last up to 2
1
/
2
years.
Wireless Chime
© 2017 HeathCo LLC 209316-01A
Figure 1
WARNING: To prevent possible
SERIOUS INJURY or DEATH:
• NEVER allow small children near
batteries.
• If battery is swallowed, immediately
notify doctor.
This package includes (Style of door sensor and chime may vary from illustration):
1. Remove orange battery tab from push
button. Remove back of case by pushing in
tab on bottom with a small screwdriver (see
Figure 1). Remove orange battery tab.
2. Install 3 alkaline “C” batteries (not includ-
ed) into chime base. Make sure batteries are
installed according to the diagram inside the
chime (see Figure 2).
IMPORTANT: To avoid resetting chime base
memory, wait 30 seconds before pressing
push button. See Troubleshooting, Problem
3 if chime memory was accidentally reset.
C
H
I
M
E
V
O
L
U
M
E
3x - “C” TYPE BATTERIES
TYPE “C”
TYPE “C”
TYPE “C”
PRESS & HOLD TUNE–1 SEC SYNC–3 SEC RESET–10 SEC
Figure 2
Chime base Chime cover Wireless push
button
Hardware
pack
Model
C
H
I
M
E
V
O
L
U
M
E
3x - “C” TYPE BATTERIES
PRESS & HOLD TUNE–1 SEC SYNC–3 SEC RESET–10 SEC
7611
✔ ✔ ✔ ✔
7464
✔ ✔ ✔ ✔