Instructions / Assembly

-3-200199-01
Use Optional
Spacer if Needed
6. Mount sensor.
 Remove back of case by
pushing in tab on bottom with a small screw-
driver (see Figure 2). Note: Remove material
in screw holes (if needed) before mounting
with screws. Attach sensor back cover to
wall using two short screws (provided). Snap
sensor onto back cover.
•  Apply foam tape to the
sensor back cover. Stick sensor back cover
to frame of door in desired position. Snap
sensor onto back cover.
 Repeat step 5 to attach magnet
(and spacer if needed) to door using two screws
(provided). Note: If using spacer, use the two
long screws (provided).
Figure 5