Manual

7
204028-01
SPECIFICATIONS
Range........... Up to 30 ft. (9.1 m)
[varieswithsurrounding
temperature]
SensingAngle..... Upto150°
ElectricalLoad..... See rating on xture
formaximumwattage
SensorCapacity ... Upto500Watts(4.1A.)
Maximum Tungsten
Incandescent
PowerRequirements 120VAC,60Hz
OperatingModes... TEST, AUTO, and
MANUAL MODE
Time Delay ....... 1,5,10minutes
HeathCoLLCreservestherighttodiscontinue
products and to change specications at
any time without incurring any obligation
to incorporate new features in products
previouslysold.
TROUBLESHOOTING GUIDE
SYMPTOM
Light stays on
continuously.
Light flashes
on and off.
POSSIBLE CAUSE
1. Thesensorispointedtoward
aheatsourcelikeanairvent,
dryervent,orbrightly-painted
heat-reectivesurface.(Re-aim
sensor.)
2. LightcontrolisinManualMode.
(Switch to Auto.)
3. Sensitivity is set too high.
(Reduce sensitivity.)
1. Heatbeingreectedfromother
objects may be affecting the
sensor.(Re-aim sensor.)
2. Light control is in the Test
mode and warming up
(flashing is normal under these
conditions).
POSSIBLE CAUSE
1. Lightswitchisturnedoff.
2. Bulbislooseorburnedout.
3. Fuseisblownorcircuitbreaker
isturnedoff.
4. Daylight turn-off is in effect
(recheck after dark).
5. Incorrectcircuitwiring, ifthis
isanewinstallation.
6. Re-aim the sensor to cover
desiredarea.
1. Lightcontrolmaybeinstalled
inarelativelydarklocation.
2. Light control is in Test. (Set
control switch to an ON-TIME
position.)
1. Light control may be sensing
small animals or automobile
trafc(re-aim sensor).
2. Sensitivity is set too high.
(Reduce sensitivity.)
SYMPTOM
Light will not
come on.
Light comes on
in daylight.
Light comes on
for no apparent
reason.