Owner's Manual
4
205436-01
3. Loosentheclampscrewinthe
sensor ball joint and gently
rotatethesensor.
4. Walk through the coverage
area noting where you are
whenthelightsturnon(also,
theLEDwillashseveraltimes
whenmotionisdetected).Move
thesensorheadup,down,or
sidewaystochangethecover-
agearea.Keep the sensor at
least 1" (25 mm) away from
the bulbs.
5. AdjusttheRANGEasneeded.
RANGE set too high may
increasefalsetriggering.
6. Secure the sensor head by
tightening the clamp screw.
Donotovertightenthescrew.
7. SettheamountofTIMEyouwantthelightstostay
onaftermotionisdetected(1,5,or20minutes).
8. SettheDualBrite
®
switchtotheamountoftimeafter
duskyouwantthelightsonatlowlevel(Off,3,6
Hrs.,Dusk-to-Dawn).
Clamp
Screw
Ball
Joint
Aim Sensor
Down for Short
Coverage
Aim Sensor
Higher for Long
Coverage
WARNING - Risk of fire. Do not aim the bulbs
at a combustible surface within 3 ft. (1 m).
Bottom of Sensor
Avoid aiming the sensor at:
•Objects that change temperature rapidly, such as
heating vents and air conditioners.These heat
sourcescouldcausefalsetriggering.
•Areaswherepets or trafficmaytriggerthecontrol.
•Nearby large, light-colored objectsreectinglight
maytriggertheshut-offfeature.Donotpointother
lightsatthesensor.
MAX
MIN
RANGE
ON-TIME
DUAL BRITE™
TEST 1 5 20
MINUTES
OFF
3
6
DUSK TO
DAWNHOUR
C
R
E
E
P
Z
O
N
E
™
B
O
O
S
T
Maximum
Maximum Range Coverage Angle
Motion
Motion
15ft.
(4.6m)
70ft. 100ft.
(21m) (30.5m)
Boosted
Sensor
240°
Least Sensitive Most Sensitive
NOTE:
Ifxtureismountedhigherthan8ft.(2.4m),aiming
thesensordownwillreducecoveragedistance.
Thedetectorislesssensitivetomotiondirectlytowardsit.
CreepZone™
CreepZone™
CreepZone™
CreepZone™
NOTE: Creep Zone™ is a new zone of detection
whichwasaddedasanoptiontoselectHeath
®
/Zenith
motionsensingproducts.Thisfeatureaddsazone
ofdetectionunderthemotionsensor.CreepZone™
requires no additional adjustment and operates in
conjunctionwiththeforward-lookingsensor.
TEST AND ADJUSTMENT
1. Turn on the circuit breaker and light switch.
NOTE: Sensor has a 1
1
/
2
minute warm up period
beforeitwilldetectmotion.Whenrstturned
on,wait1
1
/
2
minutes.
2. Turnthe RANGE control to the medium position
(halfway between MIN and MAX), DualBrite
®
to
OFF,andtheON-TIMEcontroltotheTESTposition.