Installation Instructions

This chime requires 2 “C” alkaline batteries (not included). In typical use,
alkaline batteries will last up to one year.
Wireless Chime
© 2016 HeathCo LLC 207354-02A
Figure 2
Figure 3
Figure 1
WARNING: To prevent possible
SERIOUS INJURY or DEATH:
• NEVER allow small children near
batteries.
• If battery is swallowed, immediately
notify doctor.
This package includes (Style of door sensor and chime may vary from illustration):
1. Remove orange battery tab from push
button. Remove back of case by pushing in
tab on bottom with a small screwdriver (see
Figure 1). Remove orange battery tab.
2. Open chime case. Press in catch on bottom
of chime and lift the case open (see Figure 2).
3. Install 2 alkaline “C” batteries. Make sure
batteries are oriented properly (see Figure 3).
4. Test range. Temporarily position chime and
push button where you want them mounted.
Press push button to verify chime and push
button work properly. If chime does not sound,
see Troubleshooting.
Model
Wireless
chime
Wireless push
button
Hardware
pack
7750
✔ ✔ ✔
Type “C”
Type “C”
SYNC:
HOLD 3 SEC
RESET:
HOLD 10 SEC