Operation Manual

HEIDENHAIN CNC PILOT 640 103

3.6 Tool measurement

The CNC PILOT supports tool calibration

 By touch-off. The setup dimensions are determined by comparing a

tool with an already measured tool.

 By touch probe (stationary of swiveling in the working space;

installed by the machine tool builder).

 By optical gauge (installed by the machine tool builder).

Calibration by touch-off is always available. If a touch probe or an

optical gauge is installed, select these measuring methods by soft

key.

If the tool dimensions are already known, you can enter the setup

dimensions directly in the "tool management" mode of operation.

 The compensation values are deleted during tool

measurement.

 Please note that for drilling and milling tools the center

is measured.

 The tools' type and orientation determine how they are

measured. Note the help graphics.