Operation Manual

HEIDENHAIN CNC PILOT 640 11
 The parameter U was added to G810 and G820 (see the smart.Turn
and DIN Programming User's Manual)
 The parameter D was added to G4 and G860 (see the smart.Turn
and DIN Programming User's Manual)
 The parameter B was added to G890 (see the smart.Turn and DIN
Programming User's Manual)
 The parameter RB was added to the units G840 "Contour milling, fig-
ures" and G84X "Pocket milling, figures" (see the smart.Turn and DIN
Programming User's Manual)
 The parameters SP and SI were added to all tapping units (see the
smart.Turn and DIN Programming User's Manual)
 G48 was introduced to allow limiting the rapid traverse rate for
rotary and linear axes (see the smart.Turn and DIN Programming
User's Manual)
 G53, G54 and G55 were introduced for zero point shifts using offset
values (see the smart.Turn and DIN Programming User's Manual)
 The functions for superimposing axis movements G725 "Eccentric
turning", G726 "Transition to eccentric" and G727 "Eccentric X" were
introduced (see the smart.Turn and DIN Programming User's Man-
ual)
 The load monitoring functions G995 "Monitoring zone definition" and
G996 "Type of load monitoring" were introduced (see the smart.Turn
and DIN Programming User's Manual)
 The AWG submode now also supports tools with quick-change
holders (see the smart.Turn and DIN Programming User's Manual)
 A tree view is available in the smart.Turn operating mode (see the
smart.Turn and DIN Programming User's Manual)
 Skip levels can be defined in the smart.Turn operating mode (see
the smart.Turn and DIN Programming User's Manual)
 A function was introduced to query information on the tool status
(see the smart.Turn and DIN Programming User's Manual)