Operation Manual

138 Teach-in mode
4.1 Working with cycles
Cycle menu
The main menu shows the cycle groups (see table below). Once a
cycle group has been selected, the soft keys for the individual cycles
appear.
You can use ICP cycles for complex contours, and DIN macros for
technologically sophisticated machining operations. In cycle
programs, the names of the ICP contours or DIN macros are at the end
of the line of the cycle.
Some cycles offer optional parameters. That means, specific
contour elements will only be machined if you set the corresponding
parameters. The identification letters for optional parameters and
parameters that are preassigned default values are displayed in gray.
The following parameters are only required in Teach-in mode:
 Starting point X, Z
 Machine data S, F, T and ID
Cycle groups Menu key
Workpiece blank
Defining standard workpiece blanks or workpiece
blanks with ICP.
Single cuts
Positioning in rapid traverse, linear and circular
single cuts, chamfers, and rounding arcs.
Turning cycles, longitudinal/transverse
Roughing and finishing cycles for turning and
facing.
Recessing and recess-turning cycles
Cycles for recessing, contour recessing,
undercuts and parting.
Thread cutting
Thread cycles, relief turns and thread repair.
Drilling
Drilling cycles and patterns for face and lateral-
surface machining.
Milling
Milling cycles and patterns for face and lateral-
surface machining.
DIN macros
Including DIN macros