Operation Manual

162 Teach-in mode
4.4 Turning cycles
Type of machining for technology database access: Roughing
Cycle run
1 calculates the proportioning of cuts (infeed)
2 Approach the workpiece from starting point for first pass
3 Move at the programmed feed rate to the contour end point Z2
4 The contour is machined depending on the contour smoothing H
5 Retract and approach for next pass
6 Repeat 3 to 5 until the contour starting point X1 is reached
7 Return to starting point on diagonal path
8 Move to the tool change point according to the G14 setting