Operation Manual

170 Teach-in mode
4.4 Turning cycles
Finishing cut, transverse
Select cut, longitudinal/transverse
Select cut transverse
Press the Finishing run soft key
The cycle finishes the contour area from contour starting point Z1
to contour end point X2.
Type of machining for technology database access: Finishing
Cycle run
1 Move in longitudinal direction from the starting point to the
contour starting point Z1
2 Finish first in transverse direction, then in longitudinal direction
3 Return in transverse direction to starting point
4 Move to the tool change point according to the G14 setting
At the end of the cycle, the tool returns to the starting
point.
Cycle parameters
X, Z Starting point
Z1 Contour starting point
X2 Contour end point
G14 Tool change point (siehe Seite 140)
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
MT M after T: M function that is executed after the tool call T.
MFS M at beginning: M function that is executed at the
beginning of the machining step.
MFE M at end: M function that is executed at the end of the
machining step.
WP Displays which workpiece spindle is used to process the
cycle (machine-dependent)
 Main drive
 Opposing spindle for rear-face machining