Operation Manual

192 Teach-in mode
4.4 Turning cycles
Type of machining for technology database access: Roughing
HR Specify primary machining direction
SX, SZ Cutting limits (siehe Seite 140)
G47 Safety clearance (siehe Seite 140)
G14 Tool change point (siehe Seite 140)
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
BP Break duration: Time span for interruption of the feed. The
chip is broken by the (intermittent) interruption of the feed.
BF Break duration: Time interval until the next break. The chip
is broken by the (intermittent) interruption of the feed.
A Approach angle (reference: Z axis)—(default: parallel
to Z axis)
W Departure angle (reference: Z axis)—(default: parallel to
Z axis)
XA, ZA Starting point of blank (only effective if no blank was
programmed):
 XA, ZA not programmed: The workpiece blank contour
is calculated from the tool position and the ICP contour.
 XA, ZA programmed: Definition of the corner point of
the workpiece blank.
MT M after T: M function that is executed after the tool call T.
MFS M at beginning: M function that is executed at the
beginning of the machining step.
MFE M at end: M function that is executed at the end of the
machining step.
WP Displays which workpiece spindle is used to process the
cycle (machine-dependent)
 Main drive
 Opposing spindle for rear-face machining