Operation Manual

196 Teach-in mode
4.4 Turning cycles
Cut, ICP contour-parallel, longitudinal finishing
Select cut, longitudinal/transverse
Select ICP contour-parallel, longitudinal
Press the Finishing run soft key
The cycle finishes the contour area defined by the ICP contour. When
the cycle is completed, the tool remains at the cycle end position.
The tool plunges with the maximum possible angle,
leaving material remaining.
Cycle parameters
X, Z Starting point
FK ICP finished part: Name of the contour to be machined
DXX Additive compensation number: 1-16 (siehe Seite 140)
G58 Contour-parallel oversize
DI Axis-parallel oversize X
DK Axis-parallel oversize Z
SX, SZ Cutting limits (siehe Seite 140)
G47 Safety clearance (siehe Seite 140)
G14 Tool change point (siehe Seite 140)
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
MT M after T: M function that is executed after the tool call T.