Operation Manual

HEIDENHAIN CNC PILOT 640 349
4.8 Milling cycles
Engraving, axial/radial
The CNC PILOT can realize the characters listed in the following table.
The text to be engraved is entered as a character string. Diacritics and
special characters that you cannot enter in the editor can be defined,
character by character, in NF. If text is defined in ID and a character is
defined in NF, the text is engraved before the character.
The engraving cycles are not available in manual operation.
Small letters Capital letters
Numerals,
diacritics
Special
characters
NF Character NF Character NF Character NF Character Meaning
97 a 65 A 48 0 32 Space
98 b 66 B 49 1 37 % Per cent sign
99 c 67 C 50 2 40 ( Opening parenthesis
100 d 68 D 51 3 41 ) Closing parenthesis
101 e 69 E 52 4 43 + Plus character
102 f 70 F 53 5 44 , Comma
103 g 71 G 54 6 45 – Minus sign
104 h 72 H 55 7 46 . Point
105 i 73 I 56 8 47 / Forward slash
106 j 74 J 57 9 58 : Colon
107 k 75 K 60 < Less than character
108 l 76 L 196 Ä 61 = Equal sign
109 m 77 M 214 Ö 62 > Greater than character
110 n 78 N 220 Ü 64 @ at
111 o 79 O 223 ß 91 [ Opening brackets
112 p 80 P 228 ä 93 ] Closing brackets
113 q 81 Q 246 ö 95 _ Underscore
114 r 82 R 252 ü 8364 Euro sign
115 s 83 S 181 µ Micro
116 t 84 T 186 ° Degrees
117 u 85 U 215 * Multiplication sign
118 v 86 V 33 ! Exclamation point
119 w 87 W 38 & Ampersand and
120 x 88 X 63 ? Question mark
121 y 89 Y 174 ® Trademark
122 z 90 Z 216 Ø Diameter sign