Operation Manual

HEIDENHAIN CNC PILOT 640 381
5.3 ICP editor in smart.Turn
Loading a contour from the cycle editing
Press the ICP menu key, then in the ICP submenu,
select the contour type.
Press the Contour list soft key. The ICP editor
shows the list of the contours created in cycle mode.
Select and load the contour.
Editing an existing contour
Position the cursor in the corresponding program section.
Press the ICP menu key, then ...
... Select Contour editing in the ICP submenu.
Press the Change ICP contour soft key.
The ICP editor displays the selected existing contour for subsequent
editing.