Operation Manual

400 ICP programming
5.7 Defining the workpiece blank
5.7 Defining the workpiece blank
In smart.Turn, the standard forms "bar" and "tube" are described with
a G function.
"Bar" blank
The function describes a cylinder.
In smart.Turn, ICP generates a G20 in the BLANK section.
"Tube" blank
The function describes a hollow cylinder.
In smart.Turn, ICP generates a G20 in the BLANK section.
"Cast part" blank
The function describes an oversize on an existing finished part
contour.
In smart.Turn, ICP generates a contour in the BLANK section.
Parameters
X Cylinder diameter
Z Length of the blank
K Right edge (distance between workpiece zero point and right
edge)
Parameters
X Diameter of hollow cylinder
Z Length of the blank
K Right edge (distance between workpiece zero point and right
edge)
I Inside diameter
Parameters
K Contour-parallel oversize